Hioki 7075 - Setting the Start Value

32
────────────────────────────────────────────────────
3.7 Waveform Sweep Settings
────────────────────────────────────────────────────
3.7.9 Setting the Start Value
Set the starting value of the item selected in "3.7.7 Selecting the Sweep
Items to Edit." Pressing the
START
(unit) button or the Start Value entry area
on the reversed row enables entry of the starting sweep value.
Frequency
Press the
START(Hz)
button to set the frequency.
The setting method is the same as direct entry in "3.4.1 Frequency/Period
Settings." However, note that even when the period or r/min units have been
used for setting, the display shows equivalent frequency units.
Amplitude
Press the
START(V)
button to set the amplitude.
The setting method is the same as direct entry in "3.4.2 Amplitude/Upper
Limit Settings." However, note that the upper limit value cannot be set and
even when the pp or RMS units have been used for setting, the display
shows equivalent peak units.
Offset
Press the
START(V)
button to set the offset. The setting method is the same
as direct entry in "3.4.3 Offset/Lower Limit Settings." However, note that the
lower limit value cannot be set.
Duty
Press the
START(%)
button to set the duty. The setting method is the same as
direct entry in "3.4.7 Duty Settings."