125
────────────────────────────────────────────────────
9.1 Notes on Use
────────────────────────────────────────────────────
CAUTION
Always hold the disc by the edges, so as not to make fingerprints on the
disc or scratch the printing.
Never touch the recorded side of the disc. Do not place the disc directly
on anything hard.
Do not wet the disc with volatile alcohol or water, as there is a possibility
of the label printing disappearing.
To write on the disc label surface, use a spirit-based felt pen. Do not use
a ball-point pen or hard-tipped pen, because there is a danger of
scratching the surface and corrupting the data. Do not use adhesive
labels.
Do not expose the disc directly to the sun's rays, or keep it in conditions
of high temperature or humidity, as there is a danger of warping, with
consequent loss of data.
To remove dirt, dust, or fingerprints from the disc, wipe with a dry cloth,
or use a CD cleaner. Always wipe radially from the inside to the outside,
and do no wipe with circular movements. Never use abrasives or solvent
cleaners.
Hioki shall not be held liable for any problems with a computer system
that arises from the use of this CD-R, or for any problem related to the
purchase of a Hioki product.
Chapter 9
7990 WAVEFORM CREATION
SOFTWARE
9.1 Notes on Use
Please note the following conditions before using the software:
The 7990 WAVEFORM CREATION SOFTWARE is the property of HIOKI
E.E. Corporation. Reproduction, copying or modifying part or all of this
software is prohibited by law, except for the purpose of creating waveform
data for the arbitrary waveform generator.
The 7990 may be modified and upgraded without notice in the interest of
improving operation.
Excepts from the 7990 in publications may be allowed with our permission.
However, use of the HIOKI trademark is not permitted.
Liability for the results of customers' use of the 7990 rests solely with the
customer, and is not the responsibility of
HIOKI
.
CD-R
To Next Page