Hioki 7075 - Disposing of the Unit

137
────────────────────────────────────────────────────
11.4 Disposing of the Unit
────────────────────────────────────────────────────
WARNING
To avoid electrocution, turn off the power switch and disconnect the
power cord and measurement cables before removing the lithium
battery.
Handle and dispose of batteries in accordance with local
regulations.
11.4 Disposing of the Unit
The unit uses a lithium battery to store output conditions and waveform data.
When disposing of the unit, disassemble it as follows to remove the lithium
battery for disposal by the appropriate method.
Tools required for disassembly
One Phillips screwdriver
One pair of wire cutters
Disassembly
1. Remove the screws in the four support feet on the rear of
the unit.
2. Remove the two screws in the handle on the side of the
unit.
3. Pull the case toward the back to remove it.
4. Remove the front-most board (MPU board), on which
the lithium battery is installed.
5. Pull up on the battery, and cut the (+) terminal off with
wire cutters.
6. Pull the battery up further.
7. Cut the (-) terminal that is hidden under the battery with
wire cutters.