EasyManua.ls Logo

Hioki 7075 - Standard Command

Hioki 7075
158 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
79
────────────────────────────────────────────────────
8.3.1 Standard Command
────────────────────────────────────────────────────
Syntax
*IDN?
Response
syntax
(Header: ON)
*IDN HIOKI,7075,0,V1.00
First field Manufacturer's name
Second field Model name
Third field "0" fixed
Fourth field Software version
Example
Transmission
Response
*IDN?
(Header: ON)
*IDN HIOKI,7075,0,V1.00
(Header: ON)
HIOKI,7075,0,V1.00
Syntax
*RST
Example
Transmission
*RST
Syntax
*
TST?
Response
syntax
(Header ON)
*TST <0/1>
(Header ON)
<0/1>
0: no error
1: error occurs
Example
Transmission
Response
*TST?
(Header ON)
TST 0
(Header OFF)
0
Memory is normal.
Function
Queries device ID (manufacturer's name,
model name, software version).
Notes
The "
*
IDN?" query is the last query
message in the program messages.
Accordingly, if another query is detected
after this query, a query error is
generated, and no response message after
the "
*
IDN?" query is produced.
With this query, if any error occurs, no
response message is produced.
Function
Resets the 7075 unit. The parameters
which are reset are initialized by the
reset function of the unit.
The following settings are not initialized.
GP-IB address, input buffer, output que,
transmit terminater, event register, enable
registers
Processing time: approx. 5 seconds
Upon normal finish, EORO in Event
Status Register 0 is set.
Function
Causes the 7075 to perform the self test,
and returns the result thereof as a
numerical data value in NR1 format (0 or
1).
Notes
With this query, if any error occurs, no
response message is produced.
Processing time: approx. 2 seconds.
Errors
(Execution error)
The test cannot be executed in the
following conditions. Initialization should
be performed before executing this
command.
With the RUN state active
If an arbitrary waveform is present
If sweep is active on a channel
8.3.1 Standard Command
*IDN?
Queries device ID (manufacturer's name, model name, software version).
*RST
Initializes the settings.
*
TST?
Requests execution of, and queries the result of, the self test.

Table of Contents