Hioki LR8450 - Selective Save Operation

152
Saving Data
Selective save operation
This section describes how the system works when [Select & Save] is selected under [SAVE key
settings].
Saving waveform data
1
Press the SAVE key.
A window will be displayed.
2
2
3
3
4
4
6
6
7
7
5
5
2
Enter the lename in the [File name] eld (up to 8 single-byte characters).
See “Text entry method” (p. 10).
When you enter a le name ending in a letter other than a number, the four-digit number 0001 will
be appended to the entered name. This trailing number will increase in increments of one for the
subsequent les.
Example:
Filename: [ABC], Format :binary
ABC0001.MEM, ABC0002.MEM, ABC0003.MEM, . . .
When you entered a le name ending in a number, the trailing number will increase in increments
of one for the subsequent les.
Example:
Filename: [ABC100], Format: binary
ABC100.MEM, ABC101.MEM, ABC102.MEM, . . .
If you do not specify a lename, a lename will be assigned automatically.
See “When saving les without specifying a lename” (p. 136).
Under [Add trigger date/time], select whether to add date and time to the lename.

Does not add the trigger activation date and time to the waveform data lename.
Adds the trigger activation date and time to the end of the waveform data lename.
When the [Add trigger date/time] check box is selected, the le is named as below.
Entered lename_191224_235959_0001.MEM (when the trigger activated at 23:59:59 on December 24, 2019)
3
Under [Media], select the media on which to save data.
SD card

, USB ash drive
4
Under [Type], select [Waveform].
HIOKI LR8450A964-03
w ww . . co m
information@itm.com1.800.561.8187