Hioki LR8450 - Controlling the Instrument with Communication Commands

292
Controlling the Instrument with Communication Commands
9.9 Controlling the Instrument with Communication
Commands
This section describes how to control and communicate with the instrument by sending
communication commands from a computer.
The instrument and computer must be connected using either a USB cable or a LAN cable.
See “Connecting the instrument to the computer with a USB cable” (p. 238).
See “Connecting the instrument to a computer with a LAN cable” (p. 247).
The instrument must be congured in order to control it using communication commands.
> >
2
2
3
3
4
4
1
1
1
Press the ENTER key while [Command settings...] is selected.
The settings window will open.
2
Under [Delimiter], select the communication command line feed code.
LF, CR+LF

3
Under [Header], select whether to add a header to command responses.
OFF

, ON
4
Press the ENTER key while [Close] is selected.
The settings window will close.
For more information about communication commands, see the “Communication Command
User Manual” on the included CD.
HIOKI LR8450A964-03
w ww . . co m
information@itm.com1.800.561.8187