Hioki LR8450 - Displaying the Certification Number

415
Displaying the Certication Number
Input type Input range +OVER −OVER NO DATA
Wire break
detection
Rotational speed 5000 r/s 2147483647 – – –
300000 r/min 2147483647 – – –
Waveform
calculations
– – –
1.7976931348623157e+308
–
CAN Unit
INF* −INF* nan* NO DATA
1.7976931348623157e+308 −1.7976931348623157e+308 1.7976931348623157e+308 1.7976931348623157e+308
*: For IEEE oat and IEEE double data types.
When performing calculations, the values in the table above are treated as follows:

: Included in calculation; –: Not included in calculation
Calculation type +OVER −OVER NO DATA
Wire break
detection
Numerical calculations
 
–

Waveform calculations
 
–

Waveform screen
(numerical value display)

*

* – –
*: Not included in average value calculations.
CAN Unit (during calculations)
Calculation type INF* −INF* nan* NO DATA
Numerical calculations
 
– –
Waveform calculations
 
– –
Waveform screen
(numerical value display)
– – – –
*: For IEEE oat and IEEE double data types.
11.16 Displaying the Certication Number
This section describes how to display the certication numbers of all kinds built into the instrument.
Instructions
1
Press and hold the QUICK SET key for at least 3 s and release.
The certication numbers of all kinds will be displayed.
The instrument cannot display the certication screen during measurement.
2
Press the ENTER key.
The display will close.
Knowledge and Information
HIOKI LR8450A964-03
w ww . . co m
information@itm.com1.800.561.8187