18
Setting Measurement Conditions
1.3 Setting Measurement Conditions
This section describes how to congure settings such as the recording interval and recording time.
Settings cannot be changed while measurement is in progress. Stop measurement and then
change the settings.
You can select the recording method.
Continuous recording
Sets the recording time setting to [Continuous].
Recording will continue until you press the STOP key. Recording can
be stopped with a trigger.
See “Stop triggers” (p. 116).
Time-specied recording
Sets the recording time setting to [Specied time].
The setting indicates the amount of time for which to record (the
recording length). Recording will stop once the set time has elapsed.
Recording can be stopped before the set time elapses with the STOP
key or a trigger.
Repeat recording
Sets the repeat recording setting to [ON].
Recording will resume after stopping (due to stop trigger conditions or
the completion of recording for the set recording time). Recording will
repeat until you press the STOP key. If the repeat recording setting is
[OFF], recording will stop after one iteration.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
