284
Sending Emails
9.8 Sending Emails
This section describes how to send email messages from the instrument to computers and mobile
handsets with email functionality. You can register up to three recipient addresses.
The instrument can send emails when the following events occur during measurement:
• Wireless module communications errors
• Battery exhaustion of the instrument or wireless modules
• Start trigger activations
• Stop trigger activations
• Alarms
• Power outage recoveries
• Internal memory full alerts
• Media full alerts
The instrument can also send emails at a regular interval via an SMTP mail server.
If alarms occur frequently, emails will also be sent frequently.
If you enable the alarm retention setting, only the rst alarm for each alarm channel will be sent.
For more information about alarm retention, see “Setting shared alarm conditions for all channels”
(p. 172).
Workow
1
Congure the LAN settings and establish a LAN connection. (p. 239)
2
Enable email transmission on the instrument. (p. 285)
3
Send a test email. (p. 288)
4
Start measurement on the instrument.
Emails will be sent via the mail server when a trigger is activated or when an alarm occurs on the
instrument.
5
Check the email transmission status.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
