Hioki LR8450 - Synchronizing the Time

217
Controlling the System
Synchronizing the time
This section describes how to synchronize the instrument’s time with an NTP server.
The LAN settings must be congured in advance.
See “9.3 Conguring and Establishing a LAN Connection” (p. 239).
> >
1
1
2
2
3
3
4
4
6
6
7
7
5
5
1
Press the ENTER key while [NTP settings...] is selected.
The settings window will open.
2
Set the [NTP client function] to [ON].
3
Under [Sync timing], select when to connect to the NTP server and set the time.
OFF

Does not set the time.
Every hour Sets the time once an hour.
Every day Sets the time once a day.
4
Under [Sync before start], select whether to connect to the NTP server and set the time
before starting measurement.
OFF

, ON
5
Under [Server address], set the address of the NTP server.
6
Press the ENTER key while [Sync now] is selected.
Once the settings have been applied, the instrument will connect to the specied NTP server and
set the time.
7
Press the ENTER key while [Apply] is selected.
The settings will be applied.
Press the ENTER key while [Cancel] is selected to close the window without changing any
settings.
Conguring System Settings
HIOKI LR8450A964-03
w ww . . co m
information@itm.com1.800.561.8187