Hioki LR8450 - Page 24

19
Setting Measurement Conditions
> >
1
1
2
2
3
3
5
5
7
7
4
4
6
6
1
Enter a title comment in the [Title comment] eld (optional).
See “Title comments” (p. 64).
2
Congure the [Start] and [Stop] settings.
You can start measurement at the specied time and date. Once measurement has started,
recording will start based on the trigger settings.
You can stop measurement at the specied time and date. Recording will stop when measurement
stops.
Between the times measurement starts and stops, recording will start and stop based on the trigger
conditions.
• Measurement start: The instrument has started measurement and is waiting for a trigger.
• Recording start: A trigger has occurred, and the instrument has started recording.
Start Manual

Starts measurement based on the START key or external I/O.
Time Starts measurement at the specied time and date.
YYYY-MM-DD HH:MM
The instrument will transition to the waveform screen at START key input and wait
until the specied time and date to start measurement.
If the specied time and date have already passed when the START key is
pressed, the instrument will start measurement immediately.
Stop Manual

Stops measurement based on the START key or external I/O.
Time Stops measurement at the specied time and date.
YYYY-MM-DD HH:MM
Pressing the STOP key during measurement will cause the instrument to stop
measurement, even if a stop time has been set.
Settings and Operation
HIOKI LR8450A964-03
w ww . . co m
information@itm.com1.800.561.8187