Hioki LR8450 - Page 291

286
Sending Emails
2
Congure the settings on the [General] tab.
• Select the address(es) to which you wish to send emails with the [Destination 1] to
[Destination
3] check boxes.
• Enter the address(es) to which you wish to send emails in the [Destination 1] to [Destination
3]
text elds.
String of up to 45 single-byte characters (example: abc@xyz.xx.xx)
• Enter either the [Mail server name] or [IP address] as specied by your network system
administrator or Internet provider.
SMTP mail server’s name
String of up to 45 single-byte characters
SMTP mail server’s IP address
_._._._ (_: 0 to 255) (example: 192.168.1.100)
• [Connection security]
Set the method to use to secure communications with the SMTP server.
Set as instructed by your network administrator or Internet provider.
None

Leaves communications unprotected.
STARTTLS Protects communications using STARTTLS.
SMTPS Protects communications using SMTPS.
• [Port number]
Set the mail server’s port number.
If the mail server uses a port other than the standard port (25), set that port number.
1 to 25

to 65535
• [Sender address]
Set the sender’s IP address.
String of up to 45 single-byte characters (example: logger@xyz.xx.xx)
• [Sender name]
Set the sender’s name.
String of up to 32 single-byte characters (example: LOGGER)
• [Add Data] (If the send condition is a start trigger, stop trigger, alarm, or regular transmission)
Select whether to attach instantaneous value data to the email.
OFF

, ON
• [Attach display image]
Select whether to attach a screenshot (PNG format) of the waveform screen to the email.
OFF

, ON
HIOKI LR8450A964-03
w ww . . co m
information@itm.com1.800.561.8187