Hitachi 902 - Stroke Identification for Sample Container; Setting of Sample Containers at S.probe Adjustment

14 - 16
(3) Stroke Identification for Sample Container
S1: Height identification of standard cup on sample
disk outer row (No. 1 position)
S2: Height identification of cup on test tube/
same as for S1 (No. 2 position)
S3: Height identification of standard cup on
sample disk inner row (W1 position) ................... STD/CONT
*1 Test tubes are settable only on the outer row. Model 902 allows height identification
for two kinds of sample containers.
(4) Setting of Sample Containers at S.probe Adjustment
*2
Container
Used
Set
Position
S1 Standard cup Standard cup Test tube Standard cup Standard cup Test tube
S2 Cup-on-tube Standard cup/
cup-on-tube
Test tube Test tube Cup-on-tube Cup-on-tube
S3 (W1) Standard cup Standard cup Standard cup Standard cup Standard cup Standard cup
*2 After S.probe readjustment, check if the stroke down to the sample container has
changed.
Sample containers
*1
Cup-on-tube Test Tube
Standard Cup/
Cup-on-tube
Test Tube/
Cup-on-tube
Standard
Cup
Standard
Cup/Test
Tube