16 - 42
16.7 Error Check Function
If the contents of the received text fall under any condition shown in Table 16-25, the analyzer
judges that there is an abnormal character and outputs an alarm.
Table 16-25
Attribute Item Details of Check Remarks
Text
information
Frame
character
An irrelevant frame character is received.
(For details, refer to Table 16-3.)
Function
character
Function character does not correspond to sample.
(For details, refer to the contents of text in 16.2.)
Example
Analyzer HOST Analyzer HOST
" A " " n "
(alarm not output) (alarm output)
" A " : Routine sample
(1) An irrelevant frame character is received.
(2) In test selecting information inquiry, a function
character differing from the contents sent from
the analyzer to host is received.
(3) Character check in the unassigned area of text
is not made on the analyzer side and alarm is
not output.
Sample
information
Sample No.
Position No.
Each number is outside the specified range excluding
the following cases.
Routine Sample Stat Sample
Disk No. 1 to 400 or space 1 to 50 or space
Position
No.
1 to 35 or space 2 to 35 or space
ID No.
ID Mode $20 to $7E (right-justified)
NO ID Mode Same as above
Error occurs when the control code of each test is any
of $00 to $1F.
If any test is outside the specified range, error occurs.
Inquiry
information
Test
selecting
information
(1) Test selecting information for a routine/stat
sample is any other than '0' to '4.'
(2) Channel count is outside the specified range.
To Next Page
Loading...
