Observe the following guidelines:
• If you replaced a drive without blocking it, click Refresh in the
Maintenance Utility window, and then check the status of the
replaced drive.
• When replacing a drive after saving data to a spare drive, the drive
status changes to Normal after performing the copy-back operation.
This operation can take up to 12 hours to perform, depending on the
configuration and drive capacity
• If the drive status is Copy incomplete, the correction-copy operation
cannot be performed because a copy-processing operation is being
performed in the parity group to which the target drive belongs. If you
are not sure about the restoration method or if the restoration fails,
contact the HDS Support Portal at
https://support.hds.com/en_us/
contact-us.html.
Restoration method: After completing other copy operations, replace
the drive using the drive-replacement procedure. For the drive
replacement, reuse the drive that was removed instead of using a new
drive.
• If the drive status is Reserved, the copy-back operation cannot be
performed because more than one copy-processing operation is being
performed in the parity group to which the copy-back source drive of
the target drive belongs. If you are not sure about the restoration
method or if the restoration fails, contact the HDS Support Portal at
https://support.hds.com/en_us/contact-us.html.
Restoration method: After completing other copy operations, replace
the drive using the drive-replacement procedure. For the drive
Replacing a drive 119
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
