Procedure
1. Remove all cables connected to the controller.
2. Loosen the blue screw that secures the controller, and then open the
lever.
3. Hold the controller with both hands, and then pull it gently and remove
it.
4. Loosen the blue screw that secures the fan.
5. Lift the fan and remove it from the connector.
6. Install the new fan into the connector of the controller.
7. Tighten the blue screw to secure the fan.
8. Check that the controller connector is in good condition (not deformed or
damaged).
9. With the right and left controller levers open completely, insert the
controller into the slot of the Controller.
10. Push the controller in all the way, and then close the right and left levers
completely.
11. Tighten the blue screw to secure the controller.
12. Connect all the cables that you removed from the controller.
Next steps
• Use the maintenance utility to restore (unblock) the controller.
134 Replacing a fan
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
