Note: If the red ALM LED is on at both power supplies, do not perform this
procedure, even if the status of the power supplies is Normal. Go to the
Customer Contact Us page at https://support.hds.com/en_us/contact-
us.html.
Procedure
1. Disconnect the power cable from the power supply to be replaced.
Remove the cable holder to disconnect the power cable from the power
supply.
2. Pull the lever open while pressing the latch on the power supply inward
with your right thumb. When the lever is completely opened, the power
supply moves forward.
3. Hold the power supply with both hands, and then pull it gently and
remove it.
4. With the lever opened completely, insert the new power supply into the
slot.
Wait at least 20 seconds, and then insert the power supply all the way
into the slot.
Replacing a power supply 149
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
