3. Log out of maintenance utility to close the window.
4. Remove the front bezel from the CBLM/CBLH.
5. Press the LAN-RST switch on the target controller (controller 1) using a
fine-tipped tool, such as a pen or screwdriver. Confirm that the amber
CTL ALM LED on the CBSS/CBSL or the amber ALM LED on the CBLM/
CBLH goes ON while the LAN-RST switch is being pressed.
LAN-RST button on CBSS/CBSL controller rear panel
LAN-RST button on CBLM/CBLH controller front panel
Troubleshooting the controller 183
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
