Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Confirm that the storage system power is turned on.
• The red STATUS LED is on at the front end module whose SFP will be
replaced.
Procedure
1. Disconnect the optical fibre cable from the SFP to be replaced.
2. Pull the SFP lever down toward you and pull out the SFP.
If you cannot remove the SFP, pull it out while pushing open the lever
toward you.
Replacing a small form-factor pluggable (SFP) 215
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
