Procedure
1. Remove the cable from the SFP+ to be replaced. Mark the port from
where the cable was removed.
2. Remove the SFP+:
a. Pull the SFP lever down toward you and pull out the SFP+. If you
cannot remove it, pull it out while pushing open the lever toward you.
b. Wait at least 10 seconds.
c. Check the SFP+ insertion direction, and then inset the SFP+ into the
port until the cable clicks into place.
220 Replacing a small form-factor pluggable (SFP)
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
