2. In the Maintenance Utility window, click Hardware --> Controller
Chassis.
3. Click the DKBs tab.
4. To display the most recent status of the controller, click Refresh.
5. Check the status of the back end module.
6. Select the back end module whose SAS cable you want to replace, and
then click Replace.
7. After checking that the appropriate back end module has been selected,
click Block.
8. When the Replace Disk Board window opens, verify that the back end
module shown in the window is the one whose SAS cables are to be
replaced, and then click Block.
Replacing a SAS cable 241
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
