Hitachi G200 - Page 368

If it does not recover after
restarting the SVP, set up
Storage Navigator again.
TRRMIS002508 ERROR
The ports necessary for the
RMI-API Server service are
unusable.
Check that the ports output to
the log are not used in another
application and change the port
number of the appropriate
application when permitted.
If you cannot change the port
number (see ), change the port
number for DKCManPrivate and
then restart the SVP. If the
applicable application port
number was changed, restart
the SVP.
TRRMIS002509 ERROR
TRRMIS002510 INFO
Output when the RMI-API
Server service stops.
To confirm that the RMI-API
Server service is stopped
normally, match it to the log
and check that TRRMIS002511
is output.
TRRMIS002511 INFO
Output when the RMI-API
Server service is stopped
normally.
TRRMIS002512 ERROR
The RMI-API Server service has
stopped.
If the condition does not
change within five minutes, run
the following procedures in
order.
1. Stop the appropriate storage
system from the Storage
Device List and restart it.
2. If the condition does not
recover using step 1, restart
the SVP.
3. If there is still no recovery,
set up Storage Navigator again.
TRRMIS002513 ERROR
The RMI-API Server service
stopped forcibly. This error
might occur when restarting the
SVP while the service is
running. When the SVP
restarted or the storage system
stopped, restart the storage
system by Storage Device List.
In other cases, the RMI-API
Server service restarts
368 Troubleshooting the storage system
Service Guide for VSP Gx00 and VSP Fx00 Models