82
Configuring Presets, Tours, Privacy Zones, Sectors, and Alarms
Configuring Default Functions: Presets and Tours
You can set the dome to go to a preset or run a preset tour or mimic tour after
being idle for a specified length of time.
To program a default function:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 5 to select Set Default Function.
3. In the FUN (function) column, type one of the following:
• P = preset (normal or advanced)
• V = preset tour
• T = mimic tour
The dome will perform the selected function after being idle for the
specified delay time. The function type (and name, if applicable) is
displayed on the screen (for example, a preset might appear as
PS =
Entrance Door
).
4. In the NUM (number) column, type the number of the preset, preset tour, or
mimic tour that you want to set as the default function. If the number is not
valid, an error message appears.
5. In the DLY (delay) column, type the time (in minutes and seconds) that
dome must be idle before it performs the default function. The maximum
delay time is 99 minutes and 59 seconds.
6. In the ENA (enabled) column, select Y (yes) to enable the default function,
or select N (no) to disable the default function.
7. Press ENTER.
8. Press ESC to exit.
Note If alarms are present, the dome processes these before performing
the default function. If motion detection is enabled, then the default
function is automatically disabled.
To Next Page
Loading...
