2
Introduction
Setup and Configuration
Setting up a complete ACUIX IP PTZ dome system typically includes the
following steps:
1. Installing the mount, adapter, or bracket to which the housing will be
attached.
2. Connecting the field wiring to the housing interface board.
3. Installing the housing to the mounting surface.
4. Configuring the dome address, protocol, baud rate, and parity settings on
the scan assembly main board.
5. Installing the scan assembly in the housing.
6. Installing the bubble.
7. Installing the Honeywell IP utility and ACUIX web client software and
configuring the dome.
8. If applicable, configuring the dome to work with DVRs and other hardware.
The protocol and address settings of the dome are configured using DIP
switches located on the scan assembly. All other dome settings—such as
presets, preset tours, mimic tours, and privacy zones—are programmed using
the ACUIX™ IP web client application and the OSD menus.
Additional Information
For the latest product information, visit the ACUIX IP PTZ dome website at
https://www.honeywellvideo.com/products/cameras/ip/pt/212587.html.
The product page contains downloadable PDF versions of data sheets, quick
references, installation and user guides, A&E specifications, product notices,
and other related documents.
To Next Page
Loading...
