EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 39
07/11
Displaying Sectors and Presets
If you have programmed sectors and presets, you can show the current sector
and/or preset on the screen.
To show/hide the sector name:
1. From the OSD main menu, press 2 to select Display Options.
2. Press 2 to turn the sector name ON or OFF (default).
Note If the dome has overlapping sectors displaying at the same time, the
two sector names alternate on the screen at 1.5 second intervals.
To change where the sector name appears on the screen:
1. From the OSD main menu, press 2 to select Display Options.
2. Press 7 to select Change Sector Name Loc.
3. Use the up and down arrow keys on the keyboard to position the sector
name on the screen and then press ENTER when done.
To show/hide the preset name:
1. From the OSD main menu, press 2 to select Display Options.
2. Press 3 to turn the preset names ON or OFF (default).
Displaying the Zoom Magnification
You can show the camera’s current digital zoom magnification level on the
screen.
To show/hide the digital zoom magnification:
1. From the OSD main menu, press 2 to select Display Options.
2. Press 4 to turn the digital zoom magnification ON or OFF (default).
To Next Page
Loading...
