Honeywell equIP Series Installation And Configuration Guide

EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 119
07/11
Special Presets
Presets 72 to 99 are "special presets" reserved for controlling and programming
the dome (see
Table A-8 ).
You can go to a special preset from either the
Live View tab or the PTZ Dome
Setup
tab.
To go to a special preset:
•In the PTZ Settings panel, under Preset Details, enter the special preset,
and then click Goto.
Note You can only go to those special presets that are supported by your
dome’s communication protocol.
Table A-8 Special Presets
Preset Function Protocol
72 Recover encrypted user login Diamond, IntelliBus™,
MAXPRO-mode, VCL, Pelco P,
Pelco D
73 Enable broadcast command receive mode
Diamond, MAXPRO-mode, VCL,
Pelco P, Pelco D
74 Disable broadcast command receive mode
75 Administrator/password/PIN settings:
•User login PIN
•Change PIN
•System info
• Change address, protocol
Diamond, IntelliBus™,
MAXPRO-mode, VCL, Pelco P,
Pelco D
76 Run mimic tour 1–16
MAXPRO-mode, VCL, Pelco P,
Pelco D
77 Program mimic tour
78 Run preset tour 1–16
79 User default setting preset All
80, 81, 82 Run mimic tours 1, 2, and 3 MAXPRO-mode, VCL, Pelco P,
Pelco D
83, 84, 85 Program mimic tours 1, 2, and 3
86 End mimic tour programming mode MAXPRO-mode, VCL, Pelco P,
Pelco D
87, 88, 89 Start/run preset tours 1, 2 and 3 MAXPRO-mode, VCL, Pelco P,
Pelco D
90 Setup menu (OSD) MAXPRO-mode, VCL, Pelco P,
Pelco D

Honeywell equIP Series Specifications

General

Brand	Honeywell
Model	equIP Series
Category	Security Camera
Language	English