Honeywell equIP Series Installation And Configuration Guide

EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 63
07/11
Setting the Picture Brightness
You can adjust the brightness of the image.
To set the picture brightness:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 3 to select Video Setup.
3. Press 1 to select Exposure Level.
4. Type a value from 0 through 255 where:
• 0 = darkest
• 255 = brightest
• 70 = default
5. Press ENTER.
Note Setting the exposure level to a value other than 70 may upset auto
white balance (AWB) operation and auto exposure (AE) operation.
Setting the Maximum AGC Level
Automatic gain control (AGC) adjusts the video signal strength to compensate
for changes in light levels.
To set the maximum AGC level:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 3 to select Video Setup.
3. Press 2 to select Max AGC Level 0–255.
4. Type a value from 0 through 255 where:
• 0 = picture is dim, with no noise
• 255 = picture is bright, with noise
• 216 = default
5. Press ENTER.

Honeywell equIP Series Specifications

General

Brand	Honeywell
Model	equIP Series
Category	Security Camera
Language	English