EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 87
07/11
Deleting a Privacy Zone
You can delete a privacy zone that you have programmed.
To delete a privacy zone:
1. Click the PTZ Dome Setup tab.
2. In the PTZ Settings panel, under Sector/Privacy Zone Details, click
Program.
3. Press P.
4. Type a password for the privacy zone or press ENTER to enter a blank
password (default).
5. Type the number of the privacy zone that you want to delete and then press
ENTER.
6. Press ENTER again.
7. Press D to delete the privacy zone.
8. Press ESC to exit.
To delete all privacy zones:
1. From the OSD main menu, press 6 to select Function Programming.
2. Press 3 to select Privacy Zone Options.
3. Type the password (or leave blank if none) and press ENTER.
4. Press 4 to select Delete All Privacyzones.
The following message appears:
EXTREME CAUTION: This will delete all privacy zones. Are you sure
that you want to do this? Y/N
Press Y (yes) to continue, or press N (no) to cancel.
To Next Page
Loading...
