14
Installing the Housing
If you are installing the mounting bracket to a corner or pole adapter, line
up the hole pattern on the mounting bracket with the hole pattern on the
corner or pole adapter.
2. If required, install a safety cable to anchor the housing to a structural
member.
3. Attach the mounting bracket to the mounting surface using appropriate
mounting hardware.
4. Position the housing main body so that it is parallel to the horizon. To adjust
the position of the housing main body:
a. Loosen the two bolts that secure the mounting bracket to the housing
main body.
b. Make the required adjustments.
c. Re-tighten the bolts.
5. Install the supplied 0.75-in. (19 mm) conduit fitting on the housing.
6. Place the supplied gasket between the hole on the housing and the conduit
fitting, and then tighten the conduit nut to create a watertight seal.
7. Route the field wiring through the hole in the housing and through the
access hole in the housing interface board.
8. Install the supplied ferrite bead on the power cable as close to the housing
as possible, preferably within 24 in. (609 mm).
To Next Page
Loading...
Need help?
General
