EasyManuals Logo

Honeywell equIP Series Installation And Configuration Guide

Honeywell equIP Series
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
32
Preparing to Configure the Dome
Device Information
Depending on what hardware is installed, there is a tab called either Device
Information or Device Settings. In both cases the IP and Firmware Settings
panel mirrors the information available on the Honeywell IP Utility main page. It
lists read–only network settings, firmware settings, and video formats.
Figure 4-5 IP and Firmware Settings and Device Reset Panels
PTZ Dome Setup
In the PTZ Dome Setup tab, you can go to or program presets; run, program, or
delete mimic tours, preset tours, sectors, and privacy zones; or configure dome
settings by means of the on-screen display (OSD) main menu.
Device Name as entered in the
IP Utility program
IP Address on the network
(DHCP/Static/APIPA)
Firmware Settings display
product name and version
Video Format - NTSC or PAL
Subnet Mask and Default Gateway
address on the network
MAC Address is a factory assigned
address unique to each device

Table of Contents

Other manuals for Honeywell equIP Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell equIP Series and is the answer not in the manual?

Honeywell equIP Series Specifications

General IconGeneral
BrandHoneywell
ModelequIP Series
CategorySecurity Camera
LanguageEnglish

Related product manuals