EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 97
07/11
Configuring Tamper Detection Settings
You can set tamper detection parameters for the video signal. When any of the
parameters are exceeded, a message appears on the screen to notify you of
potential tampering.
All tamper detection settings are disabled by default. However, to avoid false
alarms, Honeywell Systems recommends that you:
• Disable ALL thresholds (blur, blinding, and scene change):
• When a large part of the image is covered by the privacy zone.
• When the video is captured under low light conditions.
• When you restart the dome.
• Disable the scene change threshold:
• When running any preset tour or mimic tour.
• When the OSD menu is enabled or any other text is overlaid on the
video.
Setting the Blur Threshold
You can set the amount of blur that is acceptable, before a notification is
triggered alerting the operator to potential tampering.
To set the blur threshold:
1. Click the Video Analytics tab.
2. In the Tamper Detection Settings panel, in the Blur Threshold box, select
one of the following:
• Disable (default)
• High (80%)
• Medium (50%)
•Low (30%)
3. Click Apply.
To Next Page
Loading...
