EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 9
07/11
Installing an In-Ceiling Housing
You can install an in-ceiling housing into a dropped (suspended) ceiling or into
a hard ceiling. For dropped ceiling installations, use a separately ordered ceiling
plate (Honeywell part number 517082-7130).
You may also require the following items (not supplied):
• Safety cable (1) — 3/32-inch (2.4 mm) diameter plastic coated aircraft cable
is recommended
• Crimping loop sleeves (2)
• Adhesive tape or a plastic channel (for hard ceilings only)
Figure 2-5 In-Ceiling Housing
To install an in-ceiling housing in a dropped ceiling:
1. Select the location where you want to install the housing and remove the
ceiling tile.
2. Place the ceiling tile inside the supplied ceiling plate (see Figure 2-6). Trim
the edges of the tile so that the tile fits snugly against the plate.
3. Cut a hole in the ceiling tile to match the hole in the ceiling plate.
Wing Tab
Wiring Access Hole
Safety Cable Bracket
Wing Tab Screw
To Next Page
Loading...
