Honeywell equIP Series - Figure 4-8 Tamper Detection and Deinterlacing Filter Settings Panels; Figure 4-9 PTZ Configuration Panel; Ptz Protocol Setup

EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 35
07/11
Figure 4-8 Tamper Detection and Deinterlacing Filter Settings Panels
PTZ Protocol Setup
In the PTZ Protocol Setup tab, you can set the camera address and protocol.
The following protocols are available:
•Pelco P
•Pelco D
• Diamond
• IntelliBus™ (recommended)
•VCL
•MAXPRO-mode
Figure 4-9 PTZ Configuration Panel
Set the Blur Threshold. Blur
can be affected by elements
such as water.
Set the Blinding Threshold.
Blinding applies to obstacles in
front of the camera lens.
Set the Scene Change
Threshold.