Document 800-04194V1 Rev A 43
07/11
6
Configuring Dome Control
This chapter contains the following sections:
• Setting PASS, page 43
• Setting Auto Pivot, page 44
• Setting the Pan and Tilt Speed, page 44
• Setting Pan Reverse, page 45
• Setting Tilt Reverse, page 45
• Setting the Tilt Limit, page 45
• Finding Home on Startup, page 46
• Setting the Pan Offset, page 46
• Setting the Startup State Restore, page 47
• Setting Auto Focus, page 48
• Setting Timed Auto Focus, page 48
Setting PASS
PASS adjusts the pan and tilt speed in proportion to the amount of zoom so that
the image on the screen appears to be moving at the same speed when
zooming in and out. When PASS is enabled, the pan and tilt speed is slowed at
telephoto zoom settings, making it easier to position the camera.
To enable/disable PASS:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 1 to set PASS to ON (default) or OFF.
To Next Page
Loading...
