Honeywell equIP Series - Setting Pan Reverse; Setting Tilt Reverse; Setting the Tilt Limit

EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 45
07/11
Setting Pan Reverse
You can reverse the pan so that a left pan command from the controller will
cause the camera to pan right and a right pan command will cause the camera
to pan left.
To enable/disable pan reverse:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 4 to select Set Pan and Tilt Options.
3. Press 2 to set pan reverse to ON or OFF (default).
Setting Tilt Reverse
You can reverse the tilt so that a tilt up command from the controller will cause
the camera to tilt down and a tilt down command will cause the camera to tilt up.
To enable/disable tilt reverse:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 4 to select Set Pan and Tilt Options.
3. Press 3 to set tilt reverse to ON or OFF (default).
Setting the Tilt Limit
You can allow the camera to tilt five degrees above the horizontal using the −5
degree tilt limit feature.
To enable/disable −5 degree tilt limit:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 4 to select Set Pan and Tilt Options.
3. Press 4 to set the tilt limit to ON or OFF (default).