40
Configuring the OSD Menu
Displaying the Startup Screen
A startup screen appears when you first power on the dome that lists the
protocol, baud rate, parity, data bits, camera type, and firmware version of the
dome. You can turn off the startup screen message so that it does not appear
the next time you power on the dome.
To show/hide the startup screen message:
1. From the OSD main menu, press 2 to select Display Options.
2. Press 5 to turn the startup screen message ON or OFF (default).
Displaying Crosshairs
You can show crosshairs on the screen to assist you in positioning the camera.
This feature is especially useful when setting up privacy zones and sectors.
To show/hide crosshairs:
1. From the OSD main menu, press 2 to select Display Options.
2. Press 8 to turn crosshairs ON or OFF (default).
Displaying the Dome Name
You can create a dome name and manage its display settings.
To create a dome name:
1. From the OSD main menu, press 2 to select Display Options.
2. Press 9 to select Dome Name Settings.
3. Press 1 to select Set Dome Name.
4. Type a name for the dome (up to 24 alphanumeric characters) and then
press ENTER.
To Next Page
Loading...
