Honeywell equIP Series Installation And Configuration Guide

48
Configuring Dome Control
Press Y (yes) to continue, or press N (no) to cancel.
Setting Auto Focus
Auto focus causes the lens to remain in focus when using zoom and/or pan and
tilt functions. The following auto focus settings are available:
• Z: The camera focuses automatically when the zoom setting changes.
• PTZ: The camera focuses automatically when using PTZ functions.
• OFF: The focus is operated manually using the controller.
To set auto focus:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 6 to set auto focus to Z (default), PTZ, or OFF.
To set preset auto focus and preset tour auto focus, see Setting Preset Auto
Focus on page 56 and Setting Preset Tour Auto Focus on page 60.
Setting Timed Auto Focus
You can set the camera to focus automatically at regular intervals of either 20,
30, 60, 120, 300, or 600 seconds.
To set timed auto focus:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 9 to set timed auto focus to OFF (default), 20, 30, 60, 120, 300, or
600.

Honeywell equIP Series Specifications

General

Brand	Honeywell
Model	equIP Series
Category	Security Camera
Language	English