Honeywell equIP Series - Page 118

98
Configuring Video
Setting the Blinding Threshold
You can set the amount of blinding that is acceptable, before a notification is
triggered alerting the operator to potential tampering.
To set the blinding threshold:
1. Click the Video Analytics tab.
2. In the Tamper Detection Settings panel, in the Blinding Threshold box,
select one of the following:
• Disable (default)
• High (80%)
• Medium (50%)
•Low (30%)
3. Click Apply.
Setting the Scene Change Threshold
You can set the amount of scene change that is acceptable, before a notification
is triggered alerting the operator to potential tampering.
To set the scene change threshold:
1. Click the Video Analytics tab.
2. In the Tamper Detection Settings panel, in the Scene Change Threshold
box, select one of the following:
• Disable (default)
• High (80%)
• Medium (50%)
•Low (30%)
3. Click Apply.