Honeywell equIP Series - Configuring Account Settings

EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 55
07/11
To set the white balance for high light or low light:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 4 to select White Balance.
3. Press 1 to set the High Light WB Mode, or press 2 to set the Low Light WB
Mode, to one of the following:
• AUTO (default): Auto White Balance mode automatically adjusts the
white balance using color information from the entire screen. It
compensates for color temperature changes from 3200 K to 7500 K.
Use this setting to control the white balance for a particular shooting
environment.
• ATW: Auto Tracing White Balance mode automatically adjusts the
white balance every time a change is detected in lighting conditions. It
compensates for color temperature changes from 2000 K to 10000 K.
Use this setting to control the white balance when lighting conditions
are variable.
• Indoor: If the lighting condition is limited to fluorescent light, you can
select the preset 3200 K base mode for more precise white balance
adjustment.
• Outdoor: If the lighting condition is limited to daylight, you can select
the preset 5800 K base mode for more precise white balance
adjustment.
To set the video gain and shutter speed for high light or low light:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 4 to select White Balance.
3. Press 3 to set Enter High Lght to one of the following:
• 0 dB, 2 dB, 4 dB, 6 dB, 8 dB, 10 dB, 12 dB, 14 dB, 16 dB, 18 dB, 20 dB,
22 dB, 24 dB, 26 dB, or 28 dB
4. Press 4 to set Enter Low Lght to one of the following:
• NTSC cameras (high light default is 1/60 s; low light default is 1/30 s):
1/4 s, 1/8 s, 1/15 s, 1/30 s, or 1/60 s
• PAL cameras (high light default is 1/50 s; low light default is 1/25 s):
1/3 s, 1/6 s, 1/12 s, 1/25 s, or 1/50 s
To enable/disable manual white balance:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 4 to select White Balance.
3. Press 5 to set manual white balance to ON or OFF (default).