EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 75
07/11
7. Select Y (yes) to define (or redefine) PTZ coordinates for the preset, or
select N (no) to continue to the Advanced Preset Parameters menu without
defining PTZ settings.
8. If Y is selected, do one of the following:
• Press Focus Near to go to PTZ mode.
• Press Focus Far to go to Menu mode.
Programming an Advanced Preset
After you have defined an advanced preset and configured PTZ settings (if
required), you can program the parameters of the preset. By default, all of the
parameters are set to NA (not applicable). When a parameter is set to NA, the
global OSD menu setting is used.
Note The list of advanced preset parameters is camera model dependent.
To program the parameters of an advanced preset:
1. Click the Live View tab.
2. In the PTZ Settings panel, in the Preset Details box, type 97, and then
click Goto.
3. Using the arrow keys on the PTZ controls (see Figure 4-3 on page 30),
enter the number of the preset you want to define as an advanced preset,
and then click Iris Open.
4. Click Focus Near to set the advanced preset to ON.
5. Click Focus Far to set the advanced preset to Local or Global:
6. Click Iris Open. When the message
Want to configure PTZ? Y/N
appears, select N (no).
7. Select the parameters you want to program and do one of the following:
• Set the parameter to ON or OFF.
• Set the parameter to Enable or Disable.
• Enter a numerical value for the parameter.
Defining Preset 79 as the User Default Setting Preset
You can define special preset 79 as the user default setting preset by creating
an advanced preset with default global settings. You can change these settings
by using preset 97 (see Defining an Advanced Preset above).
To Next Page
Loading...
