Honeywell Series 8 I/O - Page 13

Contents
R500 Series 8 I/O User's Guide xiii
April 2017 Honeywell
6.8 Defining Analog Output Channel Blocks .................................................. 188
Overview ............................................................................................................................ 188
Determining Direct/Reverse Output ................................................................................... 189
Determining Output Characterization ................................................................................. 190
Determining Calibration Compensation .............................................................................. 191
Determining Modes ............................................................................................................ 191
6.9 Defining Digital Input Channel Blocks ...................................................... 191
Overview ............................................................................................................................ 191
Determining Status Digital Input channel ........................................................................... 192
Determining Latched Digital Input channel ......................................................................... 193
6.10 Defining Digital Output Channel Blocks ............................................... 193
Overview ............................................................................................................................ 193
Determining Status Output type ......................................................................................... 195
Determining Pulse Width Modulated (PWM) Output type .................................................. 195
Determining On-Pulse and Off-Pulse Output type .............................................................. 196
Determining Initialization Request Flag .............................................................................. 198
Determining Modes ............................................................................................................ 198
Determining Output Verification ......................................................................................... 198
Determining Over-current protection .................................................................................. 199
6.11 Defining DIGITAL INPUT PULSE ACCUMULATION Channel Blocks . 199
Overview ............................................................................................................................ 199
Determining the Digital Input channel properties or DIGITAL INPUT PULSE ACCUMULATION
channel properties .............................................................................................................. 200
PV Source Selection .......................................................................................................... 201
6.12 Electronic Short-Circuit Protection (Digital Output 24VDConly) ........ 201
Non-redundant Configuration ............................................................................................. 201
Redundant Configuration ................................................................................................... 202
Electronic Short-Circuit Fault Recovery ............................................................................. 203
7. SERIES 8 I/O OPERATIONS ..................................................... 205
7.1 Overview ...................................................................................................... 205
7.2 Reviewing the Control Builder icons ........................................................ 205
Series 8 I/O block icons ..................................................................................................... 205
IOLINK icons ...................................................................................................................... 207
Block icons ......................................................................................................................... 208
Channel icons .................................................................................................................... 208
7.3 Series 8 I/O LED Descriptions .................................................................... 209
7.4 Powering up the IOM .................................................................................. 212
7.5 Activating a control strategy from the Monitoring tab ............................ 214
Starting an IOM .................................................................................................................. 214
Issuing Shutdown command .............................................................................................. 215