HP 9000 rp3410 - Logging in to the Ilo MP; Additional Setup

Installing the System
Console Setup
Chapter 3
114
Logging In to the iLO MP
To log in to the iLO MP, follow these steps:
Step 1. Access the iLO MP using the LAN, RS-232 serial port, telnet, SSH, or Web method. The iLO MP
login prompt displays.
Step 2. Log in using the default the iLO MP user name and password (Admin/Admin). The
MP Main Menu
screen displays.
TIP For security reasons, HP strongly recommends that you modify the default settings
during the initial login session. See “Modifying User Accounts and Default
Password” on page 114.
Following is the
MP Main Menu screen:
MP MAIN MENU:
CO: Console
VFP: Virtual Front Panel
CM: Command Menu
CL: Console Logs
SL: Show Event Logs
HE: Main Menu Help
X: Exit Connection
This example shows the MP Main Menu accessed through the local serial port. The list of commands displayed
on the screen can be different depending on the method of access to the iLO MP.
When logging in using the local or remote RS-232 serial ports, the login prompt may not display if another
user is logged in through these ports. Use
Ctrl-B to access the MP Main Menu and the iLO MP prompt (MP>).
Additional Setup
This section provides additional information to help you set up the iLO MP.
Modifying User Accounts and Default Password
The iLO MP comes preconfigured with default factory settings, including a default user account and
password. The two default user accounts at initial login are:
• All Rights (Administrator) level user:
login = Admin
password = Admin
• Console Rights (Operator) level user:
login = Oper
password = Oper
NOTE User account and password are case sensitive.
IMPORTANT For security reasons, HP strongly recommends that you modify the default settings during the
initial login session.
Make the following changes using any of the iLO MP user interfaces.