Chapter 6
Removing and Replacing Components
Removing and Replacing Server Covers and Bezel
152
Step 2. Release the rack latches by rotating them outward.
Figure 6-3 Release the Rack Latches
Step 3. Slide the server out of the rack until the guide-rail release clips are visible.
Insert the Server into the Rack
To insert the server into the rack, follow these steps:
Step 1. Press the rail clips on either side of the server inward and push the server into the rack until it
stops.
Step 2. Verify that the rack latches are closed.
Removing and Replacing the Top Cover on a Rack-Mounted Server
Removing the Top Cover on a Rack-Mounted Server
NOTE If you are replacing a hot-swappable item, you can leave the server on and external cables
(including the power cord) connected.
Step 1. Power off the server and disconnect the power and external cables from the back of the server.
To Next Page
Loading...
