HP 9000 rp3410 - Figure 6-46 Locking the Dual Processor Module in Place; Figure 6-47 Securing the Captive Screws

Chapter 6
Removing and Replacing Components
Removing and Replacing a Dual Processor Module
193
Step 7. Use the special processor tool to lock the dual processor module in place on the system board. To do
this, insert the special processor tool into the hole that runs down the side of the heatsink and
rotate it clockwise 180 degrees (Figure 6-46).
Figure 6-46 Locking the Dual Processor Module in Place
Step 8. Slide the sequencing retainer plate toward the front of the server.
Step 9. Screw in the four heatsink captive screws in a criss-cross torquing pattern by alternately
tightening the screws so as not to completely tighten one screw before the others.
Figure 6-47 Securing the Captive Screws
CPU Install Tool
(2.5 mm Driver or
Allen Wrench)
CPU Install Tool
Torquing Pattern
1
4
3
2