HP 9000 rp3410 - Information to Collect before You Contact Support

Installing the System
Troubleshooting
Chapter 3
129
Information to Collect Before You Contact Support
Before you contact HP support, you should:
Step 1. Check information on troubleshooting and attempt to solve the problem.
• Note failure symptoms and error indications (LEDs and messages) by checking the SEL.
• Try to determine precisely what did or did not happen.
Step 2. Collect the following information:
• The model number of the server (for example, HP 9000 rp3440)
• The product number of the server. This is found on the identification label, which is found at
the front of the unit (typically A9956A, A9951A, and so on).
• The serial number of the server. This is found on the identification label.
Step 3. Become familiar with the server configuration:
• Are you using the LAN, RS232, or Web interface to monitor the server?
• How many processors, DIMMs, and PCI cards have been installed?
• What versions of processor, memory, and PCI cards are used and where are they installed?
• What accessories are installed?
Step 4. Determine the following:
• Which firmware versions are in use?
• When did the problem start?
• Have recent changes been made to the system?
• Which operating system and version is in use?