Chapter 6
Removing and Replacing Components
Removing and Replacing the Hard Disk Drive (SCSI) Backplane
227
Step 4. Replace the top cover.
Step 5. Reconnect all power and external cables.
Step 6. Verify the PSI replacement and operation by using the system utilities. (See the Utilities chapter or
the HP Integrity and HP 9000 iLO MP Operations Guide for additional information.)
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
Removing and Replacing the Hard Disk Drive (SCSI) Backplane
Removing the Hard Drive Disk SCSI Backplane
Step 1. Power off the server and disconnect all power and external cables.
Step 2. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” on page 151.)
Step 3. Lift up on the PCI card cage release lever and the back edge of the PCI card cage and lift the PCI
card cage out of the server. (See “Removing and Replacing the PCI Card Cage” on page 200.)
Step 4. Remove fans 2 and 3. (See “Removing and Replacing System Fans” on page 161.)
Step 5. Lift up on the fan power bridge and disconnect the backplane power cable.
Figure 6-79 Open the Fan Power Bridge
To Next Page
Loading...
