Chapter 2
47
2 System Specifications
This chapter provides information on the basic system configuration, physical specifications, and
requirements for the HP 9000 rp3410 or rp3440 server.
This chapter addresses the following topics:
• “System Configuration” on page 47
• “Dimensions and Values” on page 48
• “Grounding” on page 49
• “Electrical Specifications” on page 49
• “Environmental Specifications” on page 51
• “Physical and Environmental Specifications” on page 54
System Configuration
Table 2-1 lists the minimum and maximum configuration options for the HP 9000 rp3410 and rp3440 servers.
Table 2-1 Minimum and Maximum System Configurations
Component rp3410 rp3440
Microprocessors One dual processor module with one or
two PA RISC processors enabled. Each
processor is 800 MHz/1.5 MB cache
with 32 MB or 64 MB L2 cache.
One or two dual processor modules each
containing two PA RISC processors.
Each processor is 800 MHz/1.5 MB cache
or 1 GHz/1.5 MB with 32 MB or 64 MB
L2 cache.
Memory Supports up to 12 double data rate
(DDR) registered ECC memory, in
PC2100 DIMMs. Maximum memory
capacity is 6 GB. Supported DDR
DIMM sizes: 256 MB, 512 MB, and 1
GB.
Supports up to 12 double data rate
(DDR) registered ECC Memory, in
PC2100 DIMMs. Maximum memory
capacity is 32 GB if 4 GB DIMMs are
used. Supported DDR DIMM sizes:
256MB, 512 MB, 1GB, 2GB, and 4 GB.
HDDs Three 36 GB, 15K RPM Ultra320 SCSI
hot-plug disks or
Three 73 GB, 15K RPM Ultra320 SCSI
hot-plug disks or
Three 146 GB, 10K RPM Ultra320
SCSI hot-plug disks.
Three 36 GB, 15K RPM Ultra320 SCSI
hot-plug disks or
Three 73 GB, 15K RPM Ultra320 SCSI
hot-plug disks or
Three 146 GB, 10K RPM Ultra320 SCSI
hot-plug disks.
SCSI Integrated Ultra-3 SCSI dual-channel
controller; 80 MB/s transfer rate with
one internal 68-pin connector and one
external 68-pin connector.
Integrated Ultra-3 SCSI dual-channel
controller; 80 MB/s transfer rate with
one internal 68-pin connector and one
external 68-pin connector.
LAN PCI GB, fast Ethernet controller. PCI GB, fast Ethernet controller.