HP 9000 rp3410 - Figure 3-12 Removing the Top Cover on a Pedestal-Mounted Server

Installing the System
Installing Additional Components
Chapter 3
69
Figure 3-12 Removing the Top Cover on a Pedestal-Mounted Server
Step 4. Remove the top cover.
CAUTION The server depends on the access panels being closed for proper cooling of internal
components. Operating the server with the cover removed can cause the server to
quickly overheat.
Replacing the Top Cover on a Pedestal-Mounted Server
CAUTION Secure any wires or cables in the server so they do not get cut or interfere with the replacement
of the cover.
To replace the top cover, follow these steps:
Step 1. Align the front edge of the top cover with the alignment mark on the optical drive bay.