Installing the System
Installing Additional Components
Chapter 3
76
a. Press the hard drive locking lever down into the locked position.
b. Replace the cover and bezel. (See “Removing and Replacing Server Covers and Bezels” on
page 63.)
Figure 3-21 Hard Drive Lock
Step 6. Verify the drive installation by using the system utilities.
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
• Use diagnostics provided by the offline diagnostic environment to exercise the module added.
Step 7. If rack-mounted, slide the server back into the rack until it stops.
Step 8. Check the installation of the hard disk drive by powering on the server and checking the virtual
front panel and System Event Log (SEL) for correct status for the hard disk drive.
To Next Page
Loading...
