HP 9000 rp3410 - Figure 3-41 Secure the Captive Screws; Figure 3-42 Power Module Shims

Installing the System
Installing Additional Components
Chapter 3
97
Figure 3-41 Secure the Captive Screws
Step 11. Locate the two power pod module shims on the system board. (On servers delivered with only one
dual processor module installed, the power module shims are held in place by screws with plastic
spacers over the threads.) Remove the holding screws and discard the plastic spacers. Retain the
screws for use when installing the power module.
Figure 3-42 Power Module Shims
Step 12. Slide the power pod module on the system board’s metal mounting bracket so that the power pod
module connector connects with its connector on the processor module.
CPU Install Tool
Shims
Spacers
Screws